Step 4 - The Ends
These instructions are for the two ends of the wheelbarrow and the legs. When you make the two ends be sure to make them with the rough side out.
Start with a piece of 3/4" cedar 3 1/2" wide by 55" long.
Using the pattern below lay out the pieces and cut them to the finished length and angles. To cut the top boards place them against the bottom boards and extend the end lines up.
This picture is impossible to get any information from but will give you a little idea of that the ends will look like. Go to www.runnerduck.com/images/wb_front.gif for the front pattern and www.runnerduck.com/images/wb_back.gif for the back pattern.
Cut the legs 2 1/4" X 8". Use the pattern below.
Click on picture for full pattern.
Next week we'll really have some fun making the wheel.
Return to Projects